Here are some of the questions I found it difficult to answer regarding the (relatively) new Insta360 One X action camera. That is, they required more research than I would have thought necessary.
Many of these relate to indefinite shooting outdoors. This involves the use of an external power source, as well as waterproofing / weather protection. The primary application is filming motorcycling in uncertain weather conditions, where it is not practical to stop and dismount the camera every time there is a drop of rain.
For reference, on my last trip, we were rained on for 11 hours straight returning home. We were utterly soaked, and any non-waterproof camera would have been ruined.
External Power
Q: Where is the damn USB port?
A: It's on the left side of the camera, near the base. See here.
Q: What kind of USB port is it?
A: It's a micro USB. The camera comes with a short USB-A to micro-USB adapter cable.
Q: Does the One X charge and operate from an external power source?
A: Yes, it does. The camera will charge and operate from external power, allowing indefinite shooting times.
(Reference here, here, here.)
Q: Will the camera run without the battery on an external power source?
A: All sources say NO, but this user was able to use the One X with no internal battery on an XT power bank.
Q: What current capacity is required for the external power source?
A: I read one reference - which I can no longer locate - that stated you needed a 2A source. Lesser sources may not fully supply the camera and result in the battery running down even though it is plugged in.
Note that many external USB battery packs are limited to an output current below 2A. These types of packs may not fully power the One X.
There are references to a similar problem affecting the Sony FDR-X3000, which is a non-360 action cam. So, though I don't understand the behavior, it is evidently possible.
Admittedly, this one does not make sense. As the 1200 mAh battery lasts 30-60 minutes, one would expect a 20-40 mA draw - not a 2A draw. Even accounting for "bursty" current consumption when writing to the SD, 2A seems excessive.
Plus the camera would likely overheat at such draws, which it does not, and users would likely be complaining that some battery packs don't work, which they are not.
(This reference cites the battery chargers at 2A, but that is not the same thing. Obviously you want to charge the batteries as quickly as reasonably possible, but that has nothing to do with camera current draw.)
Q: Does the software stitch out the USB cable?
A: Surprisingly, it seems it (mostly) can. Not quite fully, but the cable is mostly invisible. At worst, it should be quite easy to work around.
I would recommend using a right-angle plug and taping / arranging the cable directly to the body of the camera in order to minimize exposure, as shown in this video.
Astute viewers will note the bike owner used a USB cable with a fat ferrite core near the plug. This was actually the USB adapter cable that ships with the camera (see 3:30 of this unboxing video), to which he presumably added a USB extension cable. Even with this relatively giant core, the One X software eliminates nearly all of it.
One should be able to get a lower-profile USB cable third-party, in which case it might be fully stitched out. The ferrite will be unnecessary since the longer cable will (presumably) only be used for power, and not data transfer.
(Sample video here.)
Note that all videos from "A Bike Thing" shows his bike lights strobing. This is an artifact of the video recording process, and is not happening in real life.
Venture Case / Dive Case
Q: Does the Venture Case / Dive Case include a 1/4" tripod mount?
A: Yes, they both do. The Dive has a 1/4" socket built-in, while the Venture has a GoPro-like mount with the socket at the base.
Presumably this is so the Venture can be used with the various existing GoPro mounts on the market, as well as allowing relatively easy removal/replacement. There is no need for these capabilities with the Dive Case since you don't need quick R&R underwater.
Q: Does the software fully eliminate the Venture Case from the footage?
A: Yes. However, stitch lines may become slightly more prominent.
Note you must select the software option to stitch for the Venture Case, or else the case will be visible. See this video for an example of what happens if you stitch incorrectly. (I do not know if this occurs in camera or in post.)
(Reference here. Sample videos here, here, and here.)
Q: Does the software fully eliminate the Dive Case from the footage?
A: No - the base of the Dive Case is still visible, and you have to work around it - that is, you will need to avoid pointing the perspective at the bottom of the camera. Otherwise the case is fully invisible.
If you hold the stick a bit low, it is still possible to get a clear view of the operator (i.e. yourself, the diver) during your dive.
(Reference here. Sample videos here, here, here, here, here. If video links don't work, see original Facebook post here.)
Q: Can you use an external power plug with the Venture Case?
A: No, as there is no opening in the Venture Case for an external power plug.
If you want to do this, you'll have to drill a hole in the Venture Case and somehow seal up the opening. There are no known examples of anyone doing this (yet).
Hopefully Insta will come up with a Venture Case that includes an optional port that mates to a waterproof USB cable, like the X-PWR system for the GoPro. No comparable system yet exists for the Insta360 One X.
For those interested in such modifications, see this video for how the Venture Case operates. The camera battery compartment is on the latch side of the case, while the USB port is on the hinge side of the case.
There are no good views, but it may be possible to permanently mount a USB cable into the Venture Case and seal it up with silicone, while still allowing the camera to be inserted and removed. This is not confirmed.
(Reference here.)
Q: Can you use an external power plug with the Dive Case?
A: No. For obvious reasons, modifying the case for this capability is not recommended, as the resulting hole will never be able to seal against water pressure.
Dive time is typically limited to 45-50 minutes, at the most, due to tank limitations (novices or especially active swimmers may get only 30 minutes). Only experience will tell if the 30-60 minute battery of the One X will be enough to handle an entire dive.
(Reference here.)
Q: Does the Dive / Venture Case support a TF card extension cable?
A: This is not mentioned by Insta and is unknown / unsupported. In theory, the camera will not know that there is an extension cable, but the speed of the card might be compromised.
The thin profile of the extension cable may allow the Venture to seal even with the cable poking out; in practice, your mileage may vary.
The Dive case is unlikely to seal well under water with a TF cable poking out.
SD Card / Recording Time
Q: What kind of SD card do I need?
A: You need a microSD card of V30 speed class or better, formatted to exFAT (FAT64). Inferior cards will not be able to handle the data dump from the camera.
Some sources claim the One X has an unlimited card size, but Insta states that the maximum size is limited to 128 Gb.
Note that microSD and TF (originally known as TransFlash) cards are functionally identical.
An excellent rundown of recommended and compatible cards can be found here. Other recommendations here.
Q: How big of an SD card do I need for my recording time?
A: Without a camera in-hand this can only be estimated.
The One X (at 5.7k) has a data rate in between that of the original One (4k, 8.125 MB/s) and the Pro (8k, 43.75 MB/s). Various sources list it as 100 mbps (12.5 Mb/s) or 2 streams of 60 mbps.
Anecdotal estimates place a 60 minute video at 43 Gb, indicating that actual bitrate is closer to 100 mbps.
Assuming about 100 mbps, that is approximately 12.5 MB/s, 750 Mb/min, or 45 Gb/hr. Giving recording times of:
- 32 Gb card: 42 minutes
- 64 Gb card: 1 hour 25 minutes
- 128 Gb card: 2 hours 50 minutes
Unfortunately, this video shows an actual One X, set to 5.7k, with a 32 Gb card, having an estimated recording time of 30 minutes, not 42 minutes. 64 Gb and 128 Gb cards would top out at 1 hour and 1.5 hours, respectively. Suffice to say that extended recording in 5.7k is really not possible.
This seems to be typical of 360 cameras. This Gear360 shot (reference here) shows a 4k Gear using a 128 Gb card having a 4 hour recording time, rather than the predicted 4.7 hour time. The One X would probably get the same 4 hours when set to 4k.
IF the One X supported 256 Gb and 512 Gb cards - which it
seemingly does not - the recording times
would be about 5.5 hours and 11 hours, respectively. These would be
suitable for all-day touring, and cards are not even that expensive.
It is unknown if
the camera will actually function with such cards, or if a firmware
update may come that enables large-card support. If one
was being uncharitable, one might suspect that Insta deliberately
limited the recording time to push users towards the far more expensive
Pro models.
Note that 360 Rumors stated that the recording time was limited by file size to 30 minutes. This was apparently fixed by a firmware update.
Time-lapse video should substantially extend this time, provided you want time-lapse at all. There is an example of a 6 hour time-lapse video, shot with unknown settings on a 128 Gb card.
This video shows an actual One X with a 32 Gb card allowing 5,500 JPG (not RAW) photos when set to 18 MP. However, the camera appears to take 2 shots per photo, doubling the storage per shot. That's 45 minutes at 1 second intervals, or 3 hours 49 minutes at 5 second intervals, when doing time-lapse in photo mode.
That's with a relatively puny 32 Gb card, and using JPG. RAW and larger cards will obviously change this.
Q: Can I use an SSD instead of an SD card?
A: There is no indication anywhere that the One X supports an SSD. To get that, you need to pony up $5k for a Pro model.
Other
Q: How does the Bluetooth remote work?
A: Sample video here.
Q: What does timelapse look like?
A: Sample video here.
Q: What do embedded statistics / GPS overlays look like?
A: Sample videos here, here and here.
The camera must be wirelessly connected to a phone - or, maybe, the new GPS remote - to receive GPS data while filming. This will cut battery life.
There is little data available on how the GPS overlay works. I don't know if the overlays are added post, or are embedded in the video in real time. Which is, I don't know if they can be optionally added after or are forever embedded in your video.
An idea for an alternative waterproof / weatherproof case is here.
Other references:
- Insta360 One X on motorcycle
- Insta360 One X motorcycle mount example
- More motorcycle mounting options
- Philip Bloom review of One X
- A good critical video comparing the One X to the GoPro Fusion
- A good critical video on what is / was wrong with the One X
Special thanks to:
- Steve at A Bike Thing for his helpful series of videos on using the Insta360 One X for motorcycling.
- 360 Rumors for what is possibly the most complete information source on the One X available today.
No comments:
Post a Comment